This is a contribution to the Igloo Community by two people going by the name xjobb. Tizen is made to run on the ST-Ericsson Snowball single board computer booting from the MicroSD memory card.

 

Image to card:
Write the image to the card using the dd command (using the appropriate path):

dd if=tizen_snowball.img of=/dev/sdc

Features and limitations:

• Tested on Snowball SDK

• Runs from Micro SD memory card

• Mouse and keyboard support

• No hardware acceleration supported yet

• Working network

• Kernel configured for Tizen

Network setup instructions:
To log in to the Samsung Linux Platform from Minicom use the password: root
To enable the network. Use these commands in Minicom:

Example:
ifconfig eth0 10.42.43.10 netmask 255.255.255.0 up

route add default gw 10.42.43.1 dev eth0

Source igloocommunity